:	May 24, 2004

.

Remove the driver side closing trim panel.   Release the clip.   Remove the 2 screws.   Disconnect the electrical connector.

.

Remove the accelerator pedal assembly.   Release the wiring harness.   Remove the 3 nuts.   Disconnect the electrical connector.

.

:   Do not disassemble further if the component is removed for access only. Remove the accelerator pedal bracket.   Remove the 3 nuts and bolts.

.

Attach the accelerator pedal bracket.   Tighten the nuts and bolts to 10 Nm (7 lb.ft).

.

:   Make sure the electrical connector is securely connected. Install the accelerator pedal assembly.   Connect the electrical connector.   Tighten the nuts to 25 Nm (18 lb.ft).   Secure the wiring harness.

.

Install the closing trim panel.   Connect the electrical connector.   Secure the clip.   Tighten the screws.

.

Initiate a new accelerator pedal using T4.